ProcedureGantry — Covers & accessRemove/Mount
Remove and mount the dome cover
Remove and mount the gantry's dome cover to reach the slip ring and brushes behind it, after killing all power to the slip ring as the DANGER on this page requires.
Applies to
Aquilion 16 (TSX-101A)
Personnel
1 technician · Basic — identifying and switching OFF breaker NFB2, then disconnecting one connector, one cable clamp, and four screws; no electrical work beyond operating the breaker, and no adjustment or calibration is called out in source
Steps
5 steps
Source
2D201-061E*H p.62
Tools & parts
| Item | Part number | Qty |
|---|---|---|
| Screwdriver (type not specified in source) | n/a in source |
Safety
DANGER
Hazard: High voltage present in the slip ring and the brushes
Consequence: Electric shock
Avoidance: Turn OFF all the breakers on the distribution board before removing the dome cover
Full step-by-step for Remove and mount the dome cover
All 5 steps are documented in the FSELIB Aquilion 16 (TSX-101A) service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Gantry — Covers & access guides
Adjust the operating panel acrylic cover clearance4 stepsClean the FRP covers and remove the wedge/slit optical system7 stepsOpen and close the gantry front cover10 stepsRemove and remount the base and under covers13 stepsRemove and mount the Mylar sheet (ring)5 stepsRemove and remount the side cover4 steps
View all Aquilion 16 (TSX-101A) guidesSource: 2D201-061E*H p.62. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.