ProcedureGantry — Covers & accessRemove/Mount
Remove and remount the base and under covers
Remove and remount the gantry's base cover and under cover — the last two covers in the removing/mounting chapter — to reach whatever sits beneath the base of the stand and beneath the dome once the covers ahead of them are off.
Applies to
Aquilion 16 (TSX-101A)
Personnel
1 technician · Basic for the base cover (screw removal and lift); Intermediate for the under cover — the under cover sits behind a chain of five prior covers (side, front, front/rear base, rear, dome), and the dome-cover step in that chain is itself a full prerequisite procedure with its own safety requirements that this section's text does not restate (see Safety below)
Steps
13 steps
Source
2D201-061E*H p.63-64
Tools & parts
| Item | Part number | Qty |
|---|---|---|
| Screwdriver (type not specified in source) | n/a in source |
Full step-by-step for Remove and remount the base and under covers
All 13 steps are documented in the FSELIB Aquilion 16 (TSX-101A) service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Gantry — Covers & access guides
Adjust the operating panel acrylic cover clearance4 stepsClean the FRP covers and remove the wedge/slit optical system7 stepsOpen and close the gantry front cover10 stepsRemove and mount the dome cover5 stepsRemove and mount the Mylar sheet (ring)5 stepsRemove and remount the side cover4 steps
View all Aquilion 16 (TSX-101A) guidesSource: 2D201-061E*H p.63-64. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.