TroubleshootingX-ray & HVTroubleshootingTroubleshoot

Generator troubleshooting table (phenomena and countermeasures)

Work any of ten field-observed faults on the Aquilion 16's X-ray high-voltage generator — an Over mA/Over If error, a rotor-current-low error, a non-responding maintenance program or XC, an SRU status error, a pop with no exposure, an out-of-spec large mA, a falling actual kV, or an over-kV spike at the end of exposure — using the OEM's own consolidated phenomenon/cause/countermeasure table (source §8.2.14, Table 8.2-1, p.91-92).

Applies to
Aquilion 16 (TSX-101A) — X-ray & HV volume, source 2D201-064 §8.2.14 "Troubleshooting table" (Table 8.2-1, p.91-92). This is the volume's own consolidated field-phenomenon table, printed immediately after the §8.1/§8.2 error-code catalog and flowchart index (Related — xray-error-code-table) and immediately before the console hex error-code table (Related — xray-console-error-codes).
Personnel
1 technician · Intermediate — reading ten field-observed generator phenomena back to their probable cause(s) and OEM countermeasure(s): an XC-logged error code, ROM-version identification (C10031-03 or later), a maintenance-cable/JP1 jumper check, XC LED/insulation/reset-switch checks, an SRU 30-A fuse and filter-board screw check, inverter/fuse block-test work, a resistor value change (R129), a divider resistance measurement (~3780 MΩ) against a cross-referenced adjustment section, and swapping the S75 coaxial cable for another type — escalating to XC, SRU, inverter, or cable replacement per row (skill assessment derived from procedure content — not an OEM-stated skill level).
Steps
3 steps
Source
2D201-064E*H p.91-92

Full step-by-step for Generator troubleshooting table (phenomena and countermeasures)

All 3 steps are documented in the FSELIB Aquilion 16 (TSX-101A) service manual — re-authored, web-first, with the real figures from the source.

Start free trialOpen the full procedure

7-day free trial · no credit card required

Related X-ray & HV guides

X-ray tube If adjustment (remote)11 stepsCheck phantom position, run the test scan and check tube alignment10 stepsX-ray tube alignment (front/rear and left/right)12 stepsX-ray HV: XC battery, charge/discharge, starter output, cables, SRU bolts, tube bellows — 3.14-3.1919 stepsX-ray tube/heat-exchanger leakage, rotor resistance and cooling-fan checks — 3.1-3.917 stepsRun the console malfunction-diagnosis program (hwtest)0 steps
View all Aquilion 16 (TSX-101A) guides

Related error codes

00000001RECON unit ended abnormally, reconstruction queue full00000002RECON unit timed out — restart the reconstruction queue00000003RECON unit failed to start — delete the reconstruction queue00000004Helical scan aborted, reconstruction request not accepted00000005RECON unit error — incorrect parameter set / Stack Scan aborted00000006AutoImageTransfer error / reconstruction sequence error

Source: 2D201-064E*H p.91-92. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.