Preventive MaintenanceX-ray & HVReplace

X-ray HV: XC battery, charge/discharge, starter output, cables, SRU bolts, tube bellows — 3.14-3.19

Six periodic checks on the tail end of the Aquilion 16's X-ray system: back up memory and replace the XC PWB's lithium battery, verify the power-supply unit's charge/discharge timing, confirm starter output voltage, inspect XC/SRU/power-supply cables and connectors, torque-check the front SRU's molded connection bolts, and check the X-ray tube bellows for oil leakage — items **3.14** through **3.19** of the periodic X-ray-system inspection table.

Applies to
Aquilion 16 (TSX-101A)
Personnel
1 technician · Basic to Intermediate across items 3.14-3.19. Items 3.17 (cable/connector inspection) and 3.19 (bellows oil-leak check) are visual checks with no meter or tool. Item 3.14 is a basic component swap (one lithium battery) preceded by a memory backup — the full turn-off/swap/reset/readjust sequence lives in a separate, already-authored procedure (see Related). Item 3.15 (charge/discharge timing at TB2) and item 3.16 (starter output at TB5) are DC-voltage measurements against timed or fixed thresholds. Item 3.18 is a torque-wrench check restricted to the front-side SRU only. (Skill assessment derived from procedure content — not an OEM-stated skill level.)
Steps
19 steps
Source
2Y201-061E*E p.113-115

Tools & parts

ItemPart numberQty
Lithium battery (ST Microelectronics M4T2B)**AVY005-01**
Multimetern/a in source
Torque wrenchn/a in source

Full step-by-step for X-ray HV: XC battery, charge/discharge, starter output, cables, SRU bolts, tube bellows — 3.14-3.19

All 19 steps are documented in the FSELIB Aquilion 16 (TSX-101A) service manual — re-authored, web-first, with the real figures from the source.

Start free trialOpen the full procedure

7-day free trial · no credit card required

Related X-ray & HV guides

X-ray tube If adjustment (remote)11 stepsCheck phantom position, run the test scan and check tube alignment10 stepsX-ray tube alignment (front/rear and left/right)12 stepsX-ray tube/heat-exchanger leakage, rotor resistance and cooling-fan checks — 3.1-3.917 stepsGenerator troubleshooting table (phenomena and countermeasures)3 stepsRun the console malfunction-diagnosis program (hwtest)0 steps
View all Aquilion 16 (TSX-101A) guides

Related error codes

00000001RECON unit ended abnormally, reconstruction queue full00000002RECON unit timed out — restart the reconstruction queue00000003RECON unit failed to start — delete the reconstruction queue00000004Helical scan aborted, reconstruction request not accepted00000005RECON unit error — incorrect parameter set / Stack Scan aborted00000006AutoImageTransfer error / reconstruction sequence error

Source: 2Y201-061E*E p.113-115. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.