TroubleshootingGantry — Slip ringTroubleshootingTroubleshoot

Troubleshoot the slip ring section

This is the Aquilion 16 gantry mechanism's fault table for the slip ring section (4.3): three symptom groups — brushes worn abnormally, electrical noise, and discharge between phases or between a phase and ground — each broken into what to check, the probable cause, and the countermeasure to apply. The source presents this section as a text-only fault table; there is no accompanying figure for it *(logged — no visual available in source for this atom)*.

Applies to
Aquilion 16 (TSX-101A) — Gantry mechanism, source volume 2D201-061
Personnel
1 technician · Intermediate — visual/mechanical fault isolation on the slip ring and brush assembly (sliding surfaces, mounting screws, brush block alignment) plus minor mechanical remedies (clean, tighten, replace); escalate to Toshiba engineering personnel when phase-to-phase or phase-to-ground discharge is detected (skill assessment derived from procedure content — not an OEM-stated skill level)
Steps
0 steps
Source
2D201-061E*H p.40-41

Full step-by-step for Troubleshoot the slip ring section

All 0 steps are documented in the FSELIB Aquilion 16 (TSX-101A) service manual — re-authored, web-first, with the real figures from the source.

Start free trialOpen the full procedure

7-day free trial · no credit card required

Related Gantry — Slip ring guides

Replace the SRU (SRU-H / SRU-L / SRU-POWER)16 stepsRun the console malfunction-diagnosis program (hwtest)0 stepsRun the independent MHR PWB test (diagnostics) from the RTM terminal4 stepsRemove the host PC unit (PX74-07959 GR-1/GR-2)4 stepsRemove the host PC unit (PX74-08766 GR-1/GR-2)5 stepsRemove and install an RDD disk/power-supply unit (Rorke Data)5 steps
View all Aquilion 16 (TSX-101A) guides

Related error codes

00000001RECON unit ended abnormally, reconstruction queue full00000002RECON unit timed out — restart the reconstruction queue00000003RECON unit failed to start — delete the reconstruction queue00000004Helical scan aborted, reconstruction request not accepted00000005RECON unit error — incorrect parameter set / Stack Scan aborted00000006AutoImageTransfer error / reconstruction sequence error

Source: 2D201-061E*H p.40-41. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.