TroubleshootingGantry — Tilt/StandTroubleshootingTroubleshoot

Troubleshoot the tilt section

When the gantry won't tilt, tilts with an abnormal noise, or the tilt motor won't turn at all, this is the fault table the source gives for the tilt (stand) section — work it symptom-first, the same way the general method atom describes.

Applies to

Aquilion 16 (TSX-101A) — Gantry mechanism, source volume 2D201-061

Personnel

1 technician · Intermediate — mechanical fault isolation on the tilt/stand power-cylinder drive; know when to stop and escalate rather than keep chasing an internal component

Steps

3 steps

Source

2D201-061E*H p.35

Full step-by-step for Troubleshoot the tilt section

All 3 steps are documented in the FSELIB Aquilion 16 (TSX-101A) service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Gantry — Tilt/Stand guides

Manually tilt the gantry in case of malfunction4 steps Run the console malfunction-diagnosis program (hwtest)0 steps Run the independent MHR PWB test (diagnostics) from the RTM terminal4 steps Remove the host PC unit (PX74-07959 GR-1/GR-2)4 steps Remove the host PC unit (PX74-08766 GR-1/GR-2)5 steps Remove and install an RDD disk/power-supply unit (Rorke Data)5 steps

View all Aquilion 16 (TSX-101A) guides

Source: 2D201-061E*H p.35. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.