Alarm — high severityRTM REC — recon-process stage

C0020001 — "Error in recon-process" alarm on the CT console (RTM REC)

Canon Medical (Toshiba) CT error code, reported by the RTM REC (recon-process stage).

What C0020001 means

On Aquilion RX / V4-62R004 and V3.20R003 and Aquilion ONE / V4.2 and Aquilion S16 and Asteion Super4 and Aquilion 16 CT systems, status code C0020001 indicates: "Error in recon-process" alarm on the CT console (RTM REC). The code originates in the RTM REC — recon-process stage section of the RTM REC (recon-process stage). Severity level A1 (Alarm — high severity).

Reported action: Check the reconstructed images from the affected scan before releasing the patient — a failure in the recon-process can leave the image set incomplete. Note which protocol and reconstruction settings were in use, then call your service representative; the error table gives no more detail than the recon-process error itself..

Reported on Aquilion 16, Aquilion RX/V4-62R004, Aquilion ONE/V4.2, Aquilion S16, Asteion Super4 and V3.20R003. It comes from the 101:Device RTM REC group of the console error table, where the OEM text reads "Error in recon-process.", graded A1 (high-severity alarm). RTM is the real time manager on the CT console; REC is the reconstruction stage that turns the stored raw data into images.

Full troubleshooting for C0020001

The complete diagnosis, cause tree, and step-by-step remedy for the RTM REC — recon-process stage subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related RTM REC — recon-process stage codes

C0020002Reconstruction fails with a recon-process error (RTM REC)C0020003High-severity recon-process alarm during CT reconstructionC0020004Recon-process message during CT reconstruction (RTM REC)C0020005"Error in recon-process" alarm on the CT console (RTM REC)C0020006Reconstruction fails with a recon-process error (RTM REC)00000001RECON unit ended abnormally, reconstruction queue full00000002RECON unit timed out — restart the reconstruction queue00000003RECON unit failed to start — delete the reconstruction queue

Related service procedures

Run the console malfunction-diagnosis program (hwtest)Console (Diagnostics)Run the independent MHR PWB test (diagnostics) from the RTM terminalConsole (Diagnostics)Remove the host PC unit (PX74-07959 GR-1/GR-2)Console (Operation)Remove the host PC unit (PX74-08766 GR-1/GR-2)Console (Operation)Remove and install an RDD disk/power-supply unit (Rorke Data)Console (Recon)Remove and install an RDD fan unit (Rorke Data)Console (Recon)
Discuss C0020001 with other field engineers in the FSELIB forum

Source: errmsg.eng — 101:Device RTM REC table. Reference information re-authored by FSELIB — not a copy of the OEM manual.