Skip to main content
ProcedureX-ray & HVReplacementReplace

Replace the 4-MHU X-ray tube starter

Remove and replace the 4-MHU X-ray tube starter chassis on the Activion16 gantry, then set the microcomputer circuit's tube-type DIP switch for the installed tube before remounting. This is a compact FRU swap: unbolt the starter from the gantry, disconnect its cabling, reconfigure it for the tube in use, and reinstall with the mounting screws torqued and witness-marked.

Applies to
Activion16 (TSX-031A) with the 4-MHU X-ray tube starter (ST-7013) and 42-kW HFG configuration, per the source figure.
Personnel
1 technician · Field service engineer (CT gantry / X-ray & HV)
Steps
5 steps
Source
2D201-112EN*D §1.4.4 (pp.71–72)

Tools & parts

ItemPart numberQty
4-MHU X-ray tube starter (chassis assembly)ST-7013 (per source figure caption — see naming note below)1

Safety

DANGER

Hazard: Changing DIP switch S1 on the microcomputer circuit while the starter is powered

Consequence: Electric shock

Avoidance: Confirm the starter is de-energized (system power OFF at the distribution board) before touching DIP switch S1; never change S1 with power applied

Full step-by-step for Replace the 4-MHU X-ray tube starter

All 5 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

7-day free trial · no credit card required

Related X-ray & HV guides

View all Activion16 (TSX-031A) guides

Related error codes

Source: 2D201-112EN*D §1.4.4 (pp.71–72). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.

“That they may see, and know, and consider, and understand together, that the hand of the LORD hath done this.”Isaiah 41:20