Pular para o conteúdo principal
ProcedureConsoleSetup & CalibrationAdjust

Adjust the SS/ADI4 audio (gantry/console speaker and microphone VRs)

Set the sound volume and tone of the SS/ADI4 PWB's audio function — the intercom between gantry and console, plus the automatic audio message playback — using seven variable resistors (VRs) on the board: VR1, VR2, VR3, VR5, VR6, VR8, VR9. Source shows the VR locations on the board, the audio system's block diagram, and a table of what each VR adjusts and which turn direction increases or decreases

Applies to
Activion16 (TSX-031A). No model- or revision-specific restriction is stated in source. Adjusts the sound volume and tone of the SS/ADI4 PWB's intercom and automatic-audio-playback functions (gantry and console microphone + speaker signal chains).
Steps
4 steps
Source
2D201-113EN*J §4.6.6(3) 'Audio section' (pp.449-451)

Tools & parts

ItemPart numberQty
VR1 (gantry speaker volume)n/a in source1
VR2 (console speaker volume)n/a in source1
VR3 (automatic voice message playback gain)n/a in source1
VR5 (gantry microphone tone controller — midrange)n/a in source1
VR6 (gantry microphone tone controller — treble)n/a in source1
VR8 (console microphone tone controller — midrange)n/a in source1
VR9 (console microphone tone controller — treble)n/a in source1

Full step-by-step for Adjust the SS/ADI4 audio (gantry/console speaker and microphone VRs)

All 4 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Console guides

View all Activion16 (TSX-031A) guides

Source: 2D201-113EN*J §4.6.6(3) 'Audio section' (pp.449-451). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.