ProcedureX-ray TubeSetup/CalCheck
Check the X-ray tube aging (warm-up and seasoning) schedule
Run the X-ray tube's aging exposure schedule from the console — either the warm-up or the seasoning sequence — and hold the system powered ON for a minimum 30-minute period afterward before stopping.
Applies to
Activion16 (TSX-031A) X-ray tube unit, aging performed from the console. Documented in the manual as the middle step of the 'Replacing the X-ray Tube' sequence (§1.10): connection/operation check (§1.10.1) → aging (§1.10.2, this atom) → If adjustment (§1.10.3). Source does not state any model- or revision-specific restriction for this section.
Steps
0 steps
Source
2D201-113EN*J §1.10.2 'X-ray tube aging' (p.68)
Full step-by-step for Check the X-ray tube aging (warm-up and seasoning) schedule
All 0 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated X-ray Tube guides
Check the X-ray tube getter aging (heat exchanger pushbutton)0 stepsClean the heat exchanger fan (annual PM)7 stepsConnect the replacement X-ray tube and run the operation check3 stepsX-ray tube troubleshooting — discharge, oil leakage, tube interlock, noise, and no tube current (by symptom)0 stepsAdjust the SS/ADI4 audio (gantry/console speaker and microphone VRs)4 stepsClean the console mouse4 steps
View all Activion16 (TSX-031A) guidesSource: 2D201-113EN*J §1.10.2 'X-ray tube aging' (p.68). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.