Skip to main content
ProcedureX-ray TubeFunctional ChecksCheck

Check the X-ray tube getter aging (heat exchanger pushbutton)

Run the getter-aging cycle from a pushbutton on the side of the heat exchanger whenever the X-ray tube arcs frequently, and confirm completion by the yellow LED automatically going out after about 13 minutes.

Applies to
Activion16 (TSX-031A) X-ray tube unit and heat exchanger. Documented in the manual as a troubleshooting response to frequent X-ray tube arcing, in Troubleshooting (§1.11) immediately after X-ray tube troubleshooting (§1.11.3) and immediately before Heat exchanger fan cleaning (§1.11.5). Source does not state any model- or revision-specific restriction for this section.
Steps
0 steps
Source
2D201-113EN*J §1.11.4 'X-ray tube getter aging' (p.109)

Full step-by-step for Check the X-ray tube getter aging (heat exchanger pushbutton)

All 0 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

7-day free trial · no credit card required

Related X-ray Tube guides

View all Activion16 (TSX-031A) guides

Related error codes

Source: 2D201-113EN*J §1.11.4 'X-ray tube getter aging' (p.109). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.

“That they may see, and know, and consider, and understand together, that the hand of the LORD hath done this.”Isaiah 41:20