ProcedureFilm transportReplacement
Replace the Input tray
Replace the DryStar 5300's Input tray (spare part CM+343348.X) with a short crosshead screwdriver in about 15 minutes: clear the tray, pull the Input block module first, free two screws, and lift the tray away — then reverse the sequence, remembering to hold the film plate down as the new tray goes back into place.
Applies to
Drystar 5300, Type 5365/100 (source Chapter 3.5, Replacement of Parts §3.4, Edition 1 Revision 7, 2005-08-05) — Input tray, spare part CM+343348.X. The source designation carries a wildcard '.X' suffix — see Tools & parts.
Personnel
1 technician · Basic — 2 screws (A) each way, plus removing and re-installing the Input block module (§3.1) as a prerequisite step at each end of the job; no cable disconnection, calibration, or fault diagnosis is called out within this section itself (skill assessed from procedure content — not an OEM-stated skill level).
Steps
10 steps
Source
DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5 §3.4 Input tray, Edition 1 Revision 7 (2005-08-05), p.334-336
Tools & parts
| Item | Part number | Qty |
|---|---|---|
| Input tray | CM+343348.X | 1 |
| Short Crosshead screwdriver | n/a in source | 1 |
Full step-by-step for Replace the Input tray
All 10 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Film transport guides
Loading Film into the Input Tray10 stepsAdjusting the Film Positioner Unit to 11x14 Inch9 stepsReplace the Extension cable block module11 stepsReplace the Input block module7 stepsReplace the Output module0 stepsReplace the Pick up module8 steps
View all DryStar 5300 guidesSource: DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5 §3.4 Input tray, Edition 1 Revision 7 (2005-08-05), p.334-336. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.