Skip to main content
ProcedureFilm transportInstallation

Adjusting the Film Positioner Unit to 11x14 Inch

Lower and reposition the DryStar 5300's film positioner unit — 3 screws, the output tray adjustment tool, and a short wire-harness reroute — an optional printer-setup step Agfa's installation sequence calls for only when the customer will run 11x14" film instead of the printer's 14x17" default.

Applies to
DryStar 5300 — this section's own document footer labels the printer "Type 5365" (no "/100" suffix) — source Chapter 1, §3 / §3.1, Controls, Connections and Set Up Procedures (DD+DIS346.05E), Edition 1, Revision 10 (2006-01-26), document p.43-44. Another atom in this corpus (Horizontal Film Alignment), sourced from a different chapter (3.6) of this SAME document number DD+DIS346.05E, labels the same printer "Type 5365/100" — both describe the DryStar 5300 dry film imager; the discrepancy is not reconciled here. Optional step: this adjustment is only required when the customer uses 11x14" film instead of the printer's 14x17" default (source, p.43).
Personnel
Basic mechanical/electromechanical — insert an accessory tool into the output tray, remove and remount 3 screws, lower and lift a sub-assembly by hand, and reroute a wire harness into the housing. No calibration, no cable disconnection, and no PC/browser step is called out in this section. Source assigns no formal skill-level label (derived).
Steps
9 steps
Source
DD+DIS346.05E — Drystar 5300, Controls, Connections and Set Up Procedures, Chapter 1, §3 "Printer Setup" / §3.1 "Film Positioner Unit Adjustment to 11x14" if required" (chapter-footer "Chapter 1/11" through "Chapter 1/12"), Edition 1, Revision 10 (2006-01-26), document p.43-44.

Tools & parts

ItemPart numberQty
Output tray adjustment tooln/a in source1
Screwdrivern/a in source1

Full step-by-step for Adjusting the Film Positioner Unit to 11x14 Inch

All 9 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

7-day free trial · no credit card required

Related Film transport guides

View all DryStar 5300 guides

Source: DD+DIS346.05E — Drystar 5300, Controls, Connections and Set Up Procedures, Chapter 1, §3 "Printer Setup" / §3.1 "Film Positioner Unit Adjustment to 11x14" if required" (chapter-footer "Chapter 1/11" through "Chapter 1/12"), Edition 1, Revision 10 (2006-01-26), document p.43-44.. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.

“That they may see, and know, and consider, and understand together, that the hand of the LORD hath done this.”Isaiah 41:20