ProcedureFilm transportReplacement

Replace the Input block module

Replace the DryStar 5300's Input block module (spare part CM+343332.X) with a crosshead screwdriver in about 15 minutes: set the printer at a table edge with the trays hanging over it, free three screws and one connector, lift the module out, then reverse the sequence — a straightforward swap that later becomes a prerequisite step for two other procedures in this same chapter (the Input tray and the Extension cable block module).

Applies to
Drystar 5300, Type 5365/100 (source Chapter 3.5, Replacement of Parts §3.1, Edition 1 Revision 7, 2005-08-05) — Input block module, spare part CM+343332.X
Personnel
1 technician · Basic — swap a film-transport module secured by 3 screws (B) and 1 connector (A), after first positioning the printer at a table edge; no cable routing, calibration, or fault diagnosis is involved in this section (skill assessed from procedure content — not an OEM-stated skill level)
Steps
7 steps
Source
DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5 §3.1 Input block module, Edition 1 Revision 7 (2005-08-05), p.327-328

Tools & parts

ItemPart numberQty
Input block moduleCM+343332.X1
Crosshead screwdrivern/a in source1

Full step-by-step for Replace the Input block module

All 7 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Film transport guides

Loading Film into the Input Tray10 stepsAdjusting the Film Positioner Unit to 11x14 Inch9 stepsReplace the Extension cable block module11 stepsReplace the Input tray10 stepsReplace the Output module0 stepsReplace the Pick up module8 steps
View all DryStar 5300 guides

Source: DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5 §3.1 Input block module, Edition 1 Revision 7 (2005-08-05), p.327-328. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.