ProcedureFilm transportReplacement

Replace the Extension cable block module

This procedure covers removing and reinstalling the Drystar 5300's Extension cable block module (spare part CM+343348.X) — the deepest link in the printer's Input & Output area repair chain, reachable only after the Main board, Input block module, and Input tray are already off, with the cable itself freed by unplugging one connector and pulling it gently through a routing hole.

Applies to
Drystar 5300, Type 5365/100 (source Chapter 3.5, Replacement of Parts §3.5, Edition 1 Revision 7, 2005-08-05) — Extension cable block module, spare part CM+343348.X
Personnel
1 technician · Intermediate — the section's own work is a minimal 1-connector/1-cable-through-a-hole job, but reaching it requires the Main board (§2.6), Input block module (§3.1), and Input tray (§3.4) already removed — three cross-referenced procedures deep, more staging than a typical basic swap despite the light final step (skill assessed from procedure content — not an OEM-stated skill level)
Steps
11 steps
Source
DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5 §3.5 'Extension cable block module', Chapter-relative p.63-64 (document p.337-338), Edition 1, Revision 7 (2005-08-05)

Tools & parts

ItemPart numberQty
Extension cable block moduleCM+343348.X1
Crosshead screwdrivern/a in source1

Full step-by-step for Replace the Extension cable block module

All 11 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Film transport guides

Loading Film into the Input Tray10 stepsAdjusting the Film Positioner Unit to 11x14 Inch9 stepsReplace the Input block module7 stepsReplace the Input tray10 stepsReplace the Output module0 stepsReplace the Pick up module8 steps
View all DryStar 5300 guides

Source: DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, Chapter 3.5 §3.5 'Extension cable block module', Chapter-relative p.63-64 (document p.337-338), Edition 1, Revision 7 (2005-08-05). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.