What is Philips CT error code 0530H?

IDE drive found on slave connector only, primary channel. It is reported by the Host Computer (HP Workstation x2100 EMU/BIOS) on Infinion 1.5T CT systems. Severity: Alarm — hardware/component fault; subsystem: Host computer (HP Workstation x2100).

What should a field engineer do about 0530H?

Check the primary IDE cable and jumper/cable-select settings; a drive present only in the slave position with no master drive can cause detection issues. Verify master/slave configuration and connector seating.. Isolate the Host computer (HP Workstation x2100) subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the Infinion 1.5T.

Alarm — hardware/component faultHost computer (HP Workstation x2100)

0530H — IDE drive found on slave connector only, primary channel

Philips CT error code, reported by the Host Computer (HP Workstation x2100 EMU/BIOS).

What 0530H means

On Infinion 1.5T CT systems, status code 0530H indicates: IDE drive found on slave connector only, primary channel. The code originates in the Host computer (HP Workstation x2100) section of the Host Computer (HP Workstation x2100 EMU/BIOS). Severity level alarm (Alarm — hardware/component fault).

Reported action: Check the primary IDE cable and jumper/cable-select settings; a drive present only in the slave position with no master drive can cause detection issues. Verify master/slave configuration and connector seating..

Documented as EMU code 0530h in the Error Message Summary table of the HP Workstation x2100 Troubleshooting Guide, part of the Philips Infinion 1.5T MR system service documentation set. Cause/Symptom: "Found a drive on slave connector only (primary)"; short message: "IDE device error". Not confirmed by this document for other Philips systems.

Full troubleshooting for 0530H

The complete diagnosis, cause tree, and step-by-step remedy for the Host computer (HP Workstation x2100) subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related Host computer (HP Workstation x2100) codes

0000HUnclassified POST error (EMU code not matched to a specific fault)0010HCMOS checksum error (BIOS settings corrupted)0011HSystem date and time lost from CMOS/SE2P backup 0012HPC configuration lost (CMOS and SE2P backup both lost)0020HAT option ROM POST error 0040HCorrupted or missing system serial number 0041Invalid or uninitialized internal product-type flag 0060HRemote Power On (RPO) initialization failure

Discuss 0530H with other field engineers in the FSELIB forum

Source: Philips Infinion 1.5T MR system service documentation — HP Workstation x2100 Technical Reference/Troubleshooting Guide (Chapter 4, Error Message Summary). Reference information re-authored by FSELIB — not a copy of the OEM manual.