What is Philips CT error code 0060H?

Remote Power On (RPO) initialization failure. It is reported by the Host Computer (HP Workstation x2100 EMU/BIOS) on Infinion 1.5T CT systems. Severity: Warning — recoverable condition; subsystem: Host computer (HP Workstation x2100).

What should a field engineer do about 0060H?

Check the Remote Power On configuration in BIOS Setup and the LAN/RPO wake cabling on the system board; if the fault persists, the system board may require service.. Isolate the Host computer (HP Workstation x2100) subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the Infinion 1.5T.

Warning — recoverable conditionHost computer (HP Workstation x2100)

0060H — Remote Power On (RPO) initialization failure

Philips CT error code, reported by the Host Computer (HP Workstation x2100 EMU/BIOS).

What 0060H means

On Infinion 1.5T CT systems, status code 0060H indicates: Remote Power On (RPO) initialization failure. The code originates in the Host computer (HP Workstation x2100) section of the Host Computer (HP Workstation x2100 EMU/BIOS). Severity level warning (Warning — recoverable condition).

Reported action: Check the Remote Power On configuration in BIOS Setup and the LAN/RPO wake cabling on the system board; if the fault persists, the system board may require service..

Documented as EMU code 0060h in the Error Message Summary table of the HP Workstation x2100 Troubleshooting Guide, part of the Philips Infinion 1.5T MR system service documentation set. Cause/Symptom: "RPO initialization failure"; short message: "Remote power on error". Not confirmed by this document for other Philips systems.

Full troubleshooting for 0060H

The complete diagnosis, cause tree, and step-by-step remedy for the Host computer (HP Workstation x2100) subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related Host computer (HP Workstation x2100) codes

0000HUnclassified POST error (EMU code not matched to a specific fault)0010HCMOS checksum error (BIOS settings corrupted)0011HSystem date and time lost from CMOS/SE2P backup 0012HPC configuration lost (CMOS and SE2P backup both lost)0020HAT option ROM POST error 0040HCorrupted or missing system serial number 0041Invalid or uninitialized internal product-type flag 0100HKeyboard error — stuck key detected at POST

Discuss 0060H with other field engineers in the FSELIB forum

Source: Philips Infinion 1.5T MR system service documentation — HP Workstation x2100 Technical Reference/Troubleshooting Guide (Chapter 4, Error Message Summary). Reference information re-authored by FSELIB — not a copy of the OEM manual.