What is Philips CT error code 0041?

Invalid or uninitialized internal product-type flag. It is reported by the Host Computer (HP Workstation x2100 EMU/BIOS) on Infinion 1.5T CT systems. Severity: Warning — recoverable condition; subsystem: Host computer (HP Workstation x2100).

What should a field engineer do about 0041?

The internal product identification flag in system-board storage is uninitialized or corrupted. Contact HP/Philips service support to have the product type reprogrammed via BIOS Setup; this does not by itself block normal operation.. Isolate the Host computer (HP Workstation x2100) subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the Infinion 1.5T.

Warning — recoverable conditionHost computer (HP Workstation x2100)

0041 — Invalid or uninitialized internal product-type flag

Philips CT error code, reported by the Host Computer (HP Workstation x2100 EMU/BIOS).

What 0041 means

On Infinion 1.5T CT systems, status code 0041 indicates: Invalid or uninitialized internal product-type flag. The code originates in the Host computer (HP Workstation x2100) section of the Host Computer (HP Workstation x2100 EMU/BIOS). Severity level warning (Warning — recoverable condition).

Reported action: The internal product identification flag in system-board storage is uninitialized or corrupted. Contact HP/Philips service support to have the product type reprogrammed via BIOS Setup; this does not by itself block normal operation..

Documented as EMU code 0041 (printed without the trailing 'h' seen on neighboring codes in this row of the source table) in the Error Message Summary table of the HP Workstation x2100 Troubleshooting Guide, part of the Philips Infinion 1.5T MR system service documentation set. Cause/Symptom: "Product flag not initialized or bad"; short message: "Invalid internal product type". Not confirmed by this document for other Philips systems.

Full troubleshooting for 0041

The complete diagnosis, cause tree, and step-by-step remedy for the Host computer (HP Workstation x2100) subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related Host computer (HP Workstation x2100) codes

0000HUnclassified POST error (EMU code not matched to a specific fault)0010HCMOS checksum error (BIOS settings corrupted)0011HSystem date and time lost from CMOS/SE2P backup 0012HPC configuration lost (CMOS and SE2P backup both lost)0020HAT option ROM POST error 0040HCorrupted or missing system serial number 0060HRemote Power On (RPO) initialization failure 0100HKeyboard error — stuck key detected at POST

Discuss 0041 with other field engineers in the FSELIB forum

Source: Philips Infinion 1.5T MR system service documentation — HP Workstation x2100 Technical Reference/Troubleshooting Guide (Chapter 4, Error Message Summary). Reference information re-authored by FSELIB — not a copy of the OEM manual.