What is Philips CT error code 0011H?

System date and time lost from CMOS/SE2P backup. It is reported by the Host Computer (HP Workstation x2100 EMU/BIOS) on Infinion 1.5T CT systems. Severity: Warning — recoverable condition; subsystem: Host computer (HP Workstation x2100).

What should a field engineer do about 0011H?

Enter BIOS Setup and re-enter the correct system date and time. If the fault recurs after every power cycle, the onboard battery or SE2P backup circuit on the system board likely needs replacement.. Isolate the Host computer (HP Workstation x2100) subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the Infinion 1.5T.

Warning — recoverable conditionHost computer (HP Workstation x2100)

0011H — System date and time lost from CMOS/SE2P backup

Philips CT error code, reported by the Host Computer (HP Workstation x2100 EMU/BIOS).

What 0011H means

On Infinion 1.5T CT systems, status code 0011H indicates: System date and time lost from CMOS/SE2P backup. The code originates in the Host computer (HP Workstation x2100) section of the Host Computer (HP Workstation x2100 EMU/BIOS). Severity level warning (Warning — recoverable condition).

Reported action: Enter BIOS Setup and re-enter the correct system date and time. If the fault recurs after every power cycle, the onboard battery or SE2P backup circuit on the system board likely needs replacement..

Documented as EMU code 0011h in the Error Message Summary table of the HP Workstation x2100 Troubleshooting Guide, part of the Philips Infinion 1.5T MR system service documentation set. Cause/Symptom: "Date and time (CMOS backed up from SE2P)"; short message: "Date and time lost". Not confirmed by this document for other Philips systems.

Full troubleshooting for 0011H

The complete diagnosis, cause tree, and step-by-step remedy for the Host computer (HP Workstation x2100) subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related Host computer (HP Workstation x2100) codes

0000HUnclassified POST error (EMU code not matched to a specific fault)0010HCMOS checksum error (BIOS settings corrupted)0012HPC configuration lost (CMOS and SE2P backup both lost)0020HAT option ROM POST error 0040HCorrupted or missing system serial number 0041Invalid or uninitialized internal product-type flag 0060HRemote Power On (RPO) initialization failure 0100HKeyboard error — stuck key detected at POST

Discuss 0011H with other field engineers in the FSELIB forum

Source: Philips Infinion 1.5T MR system service documentation — HP Workstation x2100 Technical Reference/Troubleshooting Guide (Chapter 4, Error Message Summary). Reference information re-authored by FSELIB — not a copy of the OEM manual.