ProcedureX-ray Generator/HVFunctional ChecksCheck
Run a single-unit X-ray exposure from the console
Command a single-unit exposure of the X-ray generator from the console's own maintenance menu, using one of the two entry points the system provides for it: a DCA test or an If Remote session (the "If Remote" → "filament value remote adjustment" reading is derived from §1.10.3, not stated in §1.4.2).
Applies to
Activion16 (TSX-031A) X-ray generator/HV section, from the console (Navi-port) side. No model- or revision-specific restriction is stated in source for this task.
Steps
2 steps
Source
2D201-113EN*J §1.4.2 'Single unit exposures' (p.24)
Full step-by-step for Run a single-unit X-ray exposure from the console
All 2 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated X-ray Generator/HV guides
Adjust the If (filament) value remotely from the console31 stepsCheck the X-ray generator power-on and power-off sequence2 stepsCheck the X-ray tube current with the tube ammeter (MA-1201D)4 stepsCheck the X-ray tube voltage with the tube voltage meter (kV-201 bleeder)5 stepsHandle the high-voltage cable — removal, cleaning, and silicone-oil reassembly (CLAYMOUNT)15 stepsReplace the X-ray generator fuse2 steps
View all Activion16 (TSX-031A) guidesSource: 2D201-113EN*J §1.4.2 'Single unit exposures' (p.24). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.