ProcedureX-ray Generator/HVReplacement/FRUReplace

Replace the X-ray generator fuse

Replace a failed fuse in the X-ray high-voltage generator with a fuse of the exact same rating and type as specified — never substitute a different rating or type. Using the wrong fuse here is called out in source as a fire risk.

Applies to
Activion16 (TSX-031A) X-ray high-voltage generator. Source does not name a specific fuse location, holder designator, part number, or rating/type value in this section — confirm the fitted fuse's rating and type from its own marking/holder label or the generator's wiring diagram and parts list before replacing.
Personnel
1 technician · Field service engineer (CT X-ray generator / HV)
Steps
2 steps
Source
2D201-113EN*J §1.9.5 'Replacing the fuse' (p.63)

Tools & parts

ItemPart numberQty
Fuse (X-ray high-voltage generator)n/a in source — must match the rating and type already specified/fitted1

Safety

WARNING

Hazard: Fitting a replacement fuse of a different rating or type than specified

Consequence: Risk of fire

Avoidance: For continued protection against risk of fire, replace only with same type and rating fuse. (verbatim source WARNING)

Full step-by-step for Replace the X-ray generator fuse

All 2 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related X-ray Generator/HV guides

Adjust the If (filament) value remotely from the console31 stepsCheck the X-ray generator power-on and power-off sequence2 stepsCheck the X-ray tube current with the tube ammeter (MA-1201D)4 stepsCheck the X-ray tube voltage with the tube voltage meter (kV-201 bleeder)5 stepsHandle the high-voltage cable — removal, cleaning, and silicone-oil reassembly (CLAYMOUNT)15 stepsRetrieve and decode the XC PWB error log (direct RS-232C read + system-software XL30 console log)11 steps
View all Activion16 (TSX-031A) guides

Source: 2D201-113EN*J §1.9.5 'Replacing the fuse' (p.63). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.