Skip to main content
Preventive MaintenanceCouch/TablePreventive MaintenancePM

PM: Inspect and maintain the couch clutch/brake assembly (dry type)

Perform this preventive-maintenance task on the patient couch's clutch/brake assembly — the dry-type unit sitting between the couch's longitudinal-drive motor (M11) and the drive pulley (see the longitudinal-drive theory page in Related). It combines a routine maintenance checklist with the inspection checks to run whenever the clutch or brake misbehaves.

Applies to
Activion16 (TSX-031A). No model- or revision-specific restriction is stated in source for this task.
Personnel
"Not specified in source manual for this section"
Steps
5 steps
Source
2D201-112EN*D §2.6.8 (pp. 171-172) — Maintenance and inspection of the clutch/brake assembly

Tools & parts

ItemPart numberQty
Clutch/brake assembly (couch horizontal/longitudinal-drive, dry type)n/a in source1 (assy)
Mounting bolts / small screws (clutch/brake assembly hardware)n/a in sourceas fitted
Brake release levern/a in source1

Safety

CAUTION

Hazard: Oil, grease, or any other contaminant reaching the friction surfaces of this dry-type clutch/brake assembly

Consequence: Operation failure or suction failure of the clutch/brake

Avoidance: Never allow oil or other contaminants to reach the friction surfaces — this assembly is dry-type and must not be lubricated

CAUTION

Hazard: Armature-to-rotor clearance increasing beyond 0.5 mm as the clutch friction surface gradually abrades with use

Consequence: Operation failure or suction failure of the clutch/brake

Avoidance: Periodically check the clearance; if it exceeds 0.5 mm, stop relying on the assembly and return it to Toshiba/Canon Nasu Operations rather than continuing to run it or repairing it on-site

CAUTION

Hazard: Excessive force applied to the brake release lever when releasing the brake for a power failure or electrical problem

Consequence: The lever is deformed or damaged, and the brake can then no longer be released using the lever

Avoidance: Do not apply excessive force to the release lever; before turning the system power back ON, confirm that no force remains applied to the release lever

Full step-by-step for PM: Inspect and maintain the couch clutch/brake assembly (dry type)

All 5 steps are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with the real figures from the source.

7-day free trial · no credit card required

Related Couch/Table guides

View all Activion16 (TSX-031A) guides

Related error codes

Source: 2D201-112EN*D §2.6.8 (pp. 171-172) — Maintenance and inspection of the clutch/brake assembly. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.

“That they may see, and know, and consider, and understand together, that the hand of the LORD hath done this.”Isaiah 41:20