ProcedurePrint engineReplacement
Replace the Print drum module
Replace the DryStar 5300's Print drum module — the drum, its main drive pulley, and the drum belt that together carry the film through the printing area — as a complete assembly, using spare part **CM+343333.X**.
Applies to
DryStar 5300 (Type 5365/100)
Personnel
1 technician · Intermediate — full removal and re-installation of the drum drive train (drum, main drive pulley, drum belt, hold-down bracket, thermal print head unit interlock) with two critical reassembly checks (bearing seating, belt direction); source estimates 15 min.
Steps
2 steps
Source
DD+DIS270.05E — Drystar 5300 Repair and Service, Replacement of Parts, Chapter 4.3, p.348-354, Edition 1 Rev.7 (2005-08-05)
Tools & parts
| Item | Part number | Qty |
|---|---|---|
| Print drum module | CM+343333.X | 1 |
| Crosshead screwdriver | n/a in source | 1 |
| Waterproof pen | n/a in source | 1 |
Full step-by-step for Replace the Print drum module
All 2 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Print engine guides
Replace the Cam shaft drive15 stepsReplace the Drum drive module10 stepsReplace the Input sensors module25 stepsReplace the Main drive pulley & Drum belt13 stepsReplace the Thermal print head unit12 stepsPerform CDM (internal densitometer) calibration7 steps
View all DryStar 5300 guidesSource: DD+DIS270.05E — Drystar 5300 Repair and Service, Replacement of Parts, Chapter 4.3, p.348-354, Edition 1 Rev.7 (2005-08-05). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.