ProcedurePrint engineReplacement
Replace the Cam shaft drive
Remove and reinstall the DryStar 5300's Cam shaft drive — spare part **CM+343339.X** *(see the Tools & parts note below — this string is also used elsewhere in source for a different part)* — a 15-minute, screwdriver-and-connector job reached behind the Front cover, the Right side cover, and the Top cover.
Applies to
DryStar 5300 (Type 5365/100)
Personnel
1 technician · Basic — mechanical/electrical: reached via the Front cover (§1.1) and Right side cover (§1.2) already off and the Top cover open, then 7 screws total (5 labeled A, 2 labeled D), an EMI shield, and 2 cable connectors; no calibration or special test equipment is involved (derived from procedure content — source states no OEM skill level for this section).
Steps
15 steps
Source
DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, §4.6 Cam shaft drive, Chapter 3.5/88-90, Edition 1 Rev.7 (2005-08-05), p.362-364
Tools & parts
| Item | Part number | Qty |
|---|---|---|
| Cam shaft drive | CM+343339.X | |
| Crosshead screwdriver | n/a in source |
Full step-by-step for Replace the Cam shaft drive
All 15 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Print engine guides
Replace the Drum drive module10 stepsReplace the Input sensors module25 stepsReplace the Main drive pulley & Drum belt13 stepsReplace the Print drum module2 stepsReplace the Thermal print head unit12 stepsPerform CDM (internal densitometer) calibration7 steps
View all DryStar 5300 guidesSource: DD+DIS270.05E — Drystar 5300, Repair and Service: Replacement of Parts, §4.6 Cam shaft drive, Chapter 3.5/88-90, Edition 1 Rev.7 (2005-08-05), p.362-364. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.