ProcedureInterfaceCalibration

Image Adjustment Workflow and the Connectivity Release Document

Before touching a single modality or printer setting, check whether a Connectivity Release Document exists for this printer-modality combination — it is the DryStar 5300's documented starting point for image adjustment, and Figure 33 is the map for what to do next if it doesn't fully resolve the complaint.

Applies to

Drystar 5300, Type 5365 (this section's own footer prints "Type 5365," with no "/100" suffix) — source Chapter 1, "Controls, Connections and Set Up Procedures," DD+DIS346.05E, Edition 1, Revision 10 (2006-01-26), document p.64-65, §7.4 "Image Adjustments" and §7.4.1 "Image Adjustments as described in the Connectivity Release Document."

Personnel

Field service engineer or key-operator: locate and apply a printer-modality Connectivity Release Document from MedNet, print test images, and judge/route the outcome with the customer through the Figure 33 decision flowchart. Source assigns no formal skill-level label to this section (derived).

Steps

4 steps

Source

DD+DIS346.05E — Drystar 5300, Controls, Connections and Set Up Procedures, Chapter 1 §7.4 "Image Adjustments" + §7.4.1 "Image Adjustments as described in the Connectivity Release Document" (chapter-footers "Chapter 1 / 32" and "Chapter 1 / 33"), Edition 1, Revision 10 (2006-01-26), document p.64-65.

Full step-by-step for Image Adjustment Workflow and the Connectivity Release Document

All 4 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Interface guides

Adjusting Contrast and Sharpness at the Modality6 steps Setting Up Logical Printers (DICOM Print SCP)2 steps Setting Up the Printer-Modality DICOM Connection0 steps Perform CDM (internal densitometer) calibration7 steps Perform density reproduction check5 steps Check for dust stripes and perform TPH cleaning procedure7 steps

View all DryStar 5300 guides

Source: DD+DIS346.05E — Drystar 5300, Controls, Connections and Set Up Procedures, Chapter 1 §7.4 "Image Adjustments" + §7.4.1 "Image Adjustments as described in the Connectivity Release Document" (chapter-footers "Chapter 1 / 32" and "Chapter 1 / 33"), Edition 1, Revision 10 (2006-01-26), document p.64-65.. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.