Information / dialogXC (X-ray Controller)

B2F00000 — Time-out in the XC (X-ray Controller)

Canon Medical (Toshiba) CT error code, reported by the XC (X-ray Controller).

What B2F00000 means

On Aquilion RX / V4-62R004 and V3.20R003 and Aquilion ONE / V4.2 and Aquilion S16 and Asteion Super4 and Aquilion 16 CT systems, status code B2F00000 indicates: Time-out in the XC (X-ray Controller). The code originates in the XC (X-ray Controller) section of the XC (X-ray Controller). Severity level 1 (Information / dialog).

Reported action: A device time-out normally means the expected answer from the XC did not arrive inside the allowed window, so start with the link: retry the scan, and if it happens again check the XC connection and its power before anything else. Note whether the time-out is tied to a cold start or to a particular protocol — that distinction saves service a lot of time..

Reported on Aquilion 16, Aquilion RX/V4-62R004, Aquilion ONE/V4.2, Aquilion S16, Asteion Super4 and V3.20R003. It comes from the 4:Device XC table, where the OEM text reads "Error in XC ( time out )."

Full troubleshooting for B2F00000

The complete diagnosis, cause tree, and step-by-step remedy for the XC (X-ray Controller) subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related XC (X-ray Controller) codes

B2100000Abnormal XC (X-ray Controller) statusB2300000X-ray exposure condition prohibitedB2500000XC NACK — X-ray Controller returned a negative acknowledgmentB2600000X-ray overcurrent detected by the XCB2610000Over kV — tube voltage above the allowed value (XC)B2620000Over mA — tube current above the allowed value (XC)B2630000Exposure time exceeded — X-ray timing alarm from the XCB2910000Arc occurred during the previous scan (XC)

Related service procedures

Run the console malfunction-diagnosis program (hwtest)Console (Diagnostics)Run the independent MHR PWB test (diagnostics) from the RTM terminalConsole (Diagnostics)Remove the host PC unit (PX74-07959 GR-1/GR-2)Console (Operation)Remove the host PC unit (PX74-08766 GR-1/GR-2)Console (Operation)Remove and install an RDD disk/power-supply unit (Rorke Data)Console (Recon)Remove and install an RDD fan unit (Rorke Data)Console (Recon)
Discuss B2F00000 with other field engineers in the FSELIB forum

Source: errmsg.eng — 4:Device XC table. Reference information re-authored by FSELIB — not a copy of the OEM manual.