What is Agfa CT error code HC11206?

Upper pick-up passed sensor S19 not triggered within time-out after pick-up. It is reported by the Film Tray Pick-up Module (Upper Tray) on DryStar 5500 (Type 5364/100) and DryStar 5503 (Type 5364/300) CT systems. Severity: Alarm; subsystem: Film Tray Pick-up (Upper) — Passed Sensor S19.

What should a field engineer do about HC11206?

Open the upper input tray and remove any jammed sheet; if this recurs, check for mechanical blockage of the sheet transport. If sensor S19 is badly positioned, reposition it; if it is mechanically broken, power off the printer and replace it (Part S19).. Isolate the Film Tray Pick-up (Upper) — Passed Sensor S19 subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the DryStar 5500 (Type 5364/100) / DryStar 5503 (Type 5364/300).

AlarmFilm Tray Pick-up (Upper) — Passed Sensor S19

HC11206 — Upper pick-up passed sensor S19 not triggered within time-out after pick-up

Agfa CT error code, reported by the Film Tray Pick-up Module (Upper Tray).

What HC11206 means

On DryStar 5500 (Type 5364/100) and DryStar 5503 (Type 5364/300) CT systems, status code HC11206 indicates: Upper pick-up passed sensor S19 not triggered within time-out after pick-up. The code originates in the Film Tray Pick-up (Upper) — Passed Sensor S19 section of the Film Tray Pick-up Module (Upper Tray). Severity level alarm (Alarm).

Reported action: Open the upper input tray and remove any jammed sheet; if this recurs, check for mechanical blockage of the sheet transport. If sensor S19 is badly positioned, reposition it; if it is mechanically broken, power off the printer and replace it (Part S19)..

Raised on the Drystar 5500/5503 upper film tray pick-up module when no sheet triggers the upper pickup passed sensor S19 within the time-out limit after a pick-up. Its counterpart on the lower tray is HC11204; the continuous-activation variant of the same sensor is HC11229.

Full troubleshooting for HC11206

The complete diagnosis, cause tree, and step-by-step remedy for the Film Tray Pick-up (Upper) — Passed Sensor S19 subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related Film Tray Pick-up (Upper) — Passed Sensor S19 codes

HC11229Upper pick-up passed sensor S19 stuck on (continuous activation) at startup HC10053Themis board CPU too hot HC10100MEC PCB test failed HC10814Drum passed sensor S24 not connected or malfunctioning HC10815Drum entry sensor S23 not connected or malfunctioning HC11000Firewire cable between Crius and Themis boards not connected or faulty HC1100124V actuator power not available on the MEC board HC1100324V / 12V / 5V voltages not OK on the MEC board

Discuss HC11206 with other field engineers in the FSELIB forum

Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.