HC10908 — Exit roller motor M10 not connected or malfunctioning
Agfa CT error code, reported by the Output Sorter Module.
What HC10908 means
On DryStar 5500 and DryStar 5503 CT systems, status code HC10908 indicates: Exit roller motor M10 not connected or malfunctioning. The code originates in the Output Sorter Module — Transport Motors section of the Output Sorter Module. Severity level alarm (Alarm).
Reported action: Check the connector of M10, then connector P21 on the MEC board, then the wiring between M10 and MEC/P21 with a multimeter, fixing whatever is not OK. If the wiring is good, power off the printer and replace M10; if the fault stays, the MEC board itself has to be replaced..
Raised on the DryStar 5500/5503 output sorter module when the exit roller motor M10 is not connected or is malfunctioning. The printer shows "Call service". Filed with the other output-sorter fault codes (HC10823, HC10831-HC10835, HC10907-HC10909, HC11223-HC11224, HC11238-HC11241).
Full troubleshooting for HC10908
The complete diagnosis, cause tree, and step-by-step remedy for the Output Sorter Module — Transport Motors subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.
Open the Activion16 service manualRelated Output Sorter Module — Transport Motors codes
Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.