GE Healthcare · MR2224666
Auto Prescan Fails Due To Center Frequency Off By 2000hz.
Symptom
Loss of Center Frequency Something happened during Manual Prescan to lose center frequency.
Error message
2224666 Auto Prescan failed, signal too small. Please try Manual Prescan. Fri Jan 23 14:39:55 2004 2224666 lx-mr psc PscMainControl.cc 1271 Auto Prescan failed, signal too small. Please try Manual Prescan.
Applies to
- Product
- Profile 2 SPARC20 with AN8290Y gradients
- Software
- Profile Contour 7.67 Applies to Profile1 through 4 and Contour1 through 4. This is the last revision of software for this product line. Requires 7.66 LFC. 7.67 is a patch.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- Multicoil Bias Fault errors on multiple coils.
- Auto Prescan Failures and RF amp setup incomplete Errors Due to Defective RF amp.
- The system is unable to scan with any surface coil, get dynamic disable faults.
- Auto Prescan Fails in Body Transmit Mode With TG Reached the High Limit due to HFO Bottom RF Body Coil Assembly.
- Getting intermittent SCIM and Keyboard Errors.