GE Healthcare · MR2252231
Auto and Manual Prescan Fails Due to Z2 Shim Supply Switches Were Set to RS232 and SEC Instead of CAN and PRI.
Symptom
Auto and Manual Prescan Fails
Error message
2252231 Network Management Recovery detected on the CAN network. Recovered Node is Shim Power Supply. 2252231 mmp-mr01 NSP SCP:CanLinkHWO 663 Network Management Recovery detected on the CAN network. Recovered Node is Shim Power Supply.
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR4-HFO4 Software version for HFO4 system, which is OpenSpeed with Excite Technology
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Intermittent CAN Link errors due to failed SCP2 board.
- The CAN Link is Reporting Hard or Intermittent CAN Link Failures.
- intermittently, there is no knocking...it just counts down as if scanning. customer reboots and is able to resume scanning as normal.
- There is an error message logged indicating the "Master Gradient", or "Slave Gradient" but this is an HD system.
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged