GE Healthcare · MR2244577
Will Not Scan with Gradient Errors
Symptom
Will Not Scan with Gradient Errors.
Error message
2244577 The GP reported a % Axis Current Distortion Fault 2244577 "The GP reported a Z Axis Current Distortion Fault. If no other faults occurred, check LCoil Calibration. Else, run Gradient Driver Tests to isolate the FRU. If Tests pass, see Troubleshooting Manual."
Applies to
- Product
- 3T Eclipse For E2 software
- Software
- VH3 3T VH3
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Current Distortion Faults Due to HFA CONTROL BOARD ASSEMBLY.
- Current distortion fault due to SGA Assembly.
- Getting Z axis Gradient Current Distortion Faults when Running SPT.
- Unable to scan with DCERD Temperature Error 2266418 due to Equipment Room too Hot.
- Scan Pauses with Gradient Current Distortion and Gradient Data Overrange Errors, and Images Show a Partially Collapsed Gradient Field (White Line in Images) due to STIF Board.
- Will not Scan with Gradient Distortion Faults Due to Open Gradient Coil in BRM.Will Not Scan with Gradient Errors.SecondOpinion BRM-D 2144093-5.Excite HDx.2218527 Scanning has stopped.