GE Healthcare · MR2244577
Getting Z axis Gradient Current Distortion Faults when Running SPT.
Symptom
Getting Z axis Gradient Current Distortion Faults when Running SPT. The system is an HFO4 running HFO4 M3 software. New install. The FE is running SPT after doing the cals and after a couple of minutes of scanning Head SPT, the system stops with Z axis current distortion fault.
Error message
2244577 The GP reported a % Axis Current Distortion Fault 2244577 "The GP reported a Z Axis Current Distortion Fault. If no other faults occurred, check LCoil Calibration. Else, run Gradient Driver Tests to isolate the FRU. If Tests pass, see Troubleshooting Manual."
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR4-HFO4 Software version for HFO4 system, which is OpenSpeed with Excite Technology
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Current Distortion Faults Due to HFA CONTROL BOARD ASSEMBLY.
- Current distortion fault due to SGA Assembly.
- Unable to scan with DCERD Temperature Error 2266418 due to Equipment Room too Hot.
- Scan Pauses with Gradient Current Distortion and Gradient Data Overrange Errors, and Images Show a Partially Collapsed Gradient Field (White Line in Images) due to STIF Board.
- Will not Scan with Gradient Distortion Faults Due to Open Gradient Coil in BRM.Will Not Scan with Gradient Errors.SecondOpinion BRM-D 2144093-5.Excite HDx.2218527 Scanning has stopped.
- Current Distortion Faults Due to HFA CONTROL BOARD ASSEMBLY.