GE Healthcare · MR2224666
Table Does Not Move In Out Up or Down Due to CRADLE DRIVE BELT WAS DISENGAGED AND CRADLE WAS DISCONNECTED.
Symptom
Table Does Not Move In Out Up or Down Customer had no table functionality and the LED display on the magnet enclosure looked like it was missing segments or bits.
Error message
2224666 Auto Prescan failed The table is not at scan plane Wed Oct 19 18:25:22 2005 Error: 2224666 Host: lx-mr Process: psc File: PscMainControl.cc Line: 1322 Auto Prescan failed, The table is not at scan plane.
Applies to
- Product
- HF OpenSpeed HFO1 HFO2 and HFO3 Only.
- Software
- HFO3
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- Multicoil Bias Fault errors on multiple coils.
- Auto Prescan Failures and RF amp setup incomplete Errors Due to Defective RF amp.
- The system is unable to scan with any surface coil, get dynamic disable faults.
- Auto Prescan Fails in Body Transmit Mode With TG Reached the High Limit due to HFO Bottom RF Body Coil Assembly.
- Getting intermittent SCIM and Keyboard Errors.