GE Healthcare · MR222466722550752224666
Auto and Manual Prescan Fails
Pre Scan Fails.
Symptom
Auto and Manual Prescan Fails
Error message
2224667 Manual Prescan failed, Z2 shim power supply is not ready. 2255075 Shim Supply Current Channel 5 was found to be out of tolerance. Channel will be zeroed and shutdown until the Shim Supply is Reset. 2224666 Auto Prescan failed, Z2 shim power supply is not ready.
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR4-HFO4 Software version for HFO4 system, which is OpenSpeed with Excite Technology
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- Multicoil Bias Fault errors on multiple coils.
- Auto Prescan Failures and RF amp setup incomplete Errors Due to Defective RF amp.
- The system is unable to scan with any surface coil, get dynamic disable faults.
- Auto Prescan Fails in Body Transmit Mode With TG Reached the High Limit due to HFO Bottom RF Body Coil Assembly.
- Getting intermittent SCIM and Keyboard Errors.