Pre-upgrade baseline — record interpolation settings, film calibration, print reference test images
Before starting the SW 2.0.0_C1 upgrade, record every Host Profile's interpolation setting, run a film calibration, and print a set of reference test images — the baseline this same document later compares against once the upgrade is done.
Applies to
DryStar 5300 — this section's own document footer alternates between "(Typ 5365)" (p.466 and p.468 footers) and "(Type 5365)" (p.467 footer) — no "/100" suffix either way — source Chapter 7, §2.3/§2.4/§2.5, Field Modifications (DD+DIS350.05E), Edition 1, Revision 9 (2006-01-20), document p.466-468. Other atoms in this corpus, sourced from a different document (DD+DIS346.05E), label the same printer "Type 5365/100" — both refer to the DryStar 5300 dry film imager; not reconciled here.
Personnel
Service-level technician or key-operator: read and record settings at the key-operator menu's local keypad ("1 Show Settings" and "6 Calibration"), run and read a film calibration, and separately drive the browser-based "Service Engineer Tools - Enter Service Command Session" menu to print test films. No disassembly or measurement instrument called for in this section. Source assigns no formal skill-level label to this section (derived).
Steps
13 steps
Source
DD+DIS350.05E — Drystar 5300, Field Modifications, Chapter 7, §2.3 "Check of configured Interpolation Settings," §2.4 "Film Calibration," and §2.5 "Print-out of Test Images" (chapter-footers "Chapter 7/4" through "Chapter 7/6"), Edition 1, Revision 9 (2006-01-20), document p.466-468.
Full step-by-step for Pre-upgrade baseline — record interpolation settings, film calibration, print reference test images
All 13 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Source: DD+DIS350.05E — Drystar 5300, Field Modifications, Chapter 7, §2.3 "Check of configured Interpolation Settings," §2.4 "Film Calibration," and §2.5 "Print-out of Test Images" (chapter-footers "Chapter 7/4" through "Chapter 7/6"), Edition 1, Revision 9 (2006-01-20), document p.466-468.. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.