ProcedureSoftwareInstallation

Entering Site Data

During initial setup, fill in the DryStar 5300's site data — the name, address and contact details of the installation — or the printer will keep prompting for it on every power-on and reboot.

Applies to

DryStar 5300, Type 5365 — source Chapter 1 "Controls, Connections and Set Up Procedures," §5.6 "Entering Site Data," Repair and Service manual DD+DIS346.05E, Edition 1, Revision 10 (2006-01-26), document p.56 (chapter-relative footer "Chapter 1 / 24").

Personnel

1 technician · Basic — browser navigation and typing text into a settings form; no measurement, calibration or disassembly involved. Source assigns no formal skill-level label to this section (derived).

Steps

0 steps

Source

DD+DIS346.05E — Drystar 5300, Repair and Service: Controls, Connections and Set Up Procedures, Chapter 1 §5.6 "Entering Site Data", Edition 1, Revision 10 (2006-01-26), document p.56 (chapter-relative footer "Chapter 1 / 24")

Full step-by-step for Entering Site Data

All 0 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Software guides

ADVP — DICOM Test Tool6 steps Printer Bootup-Message via HyperTerminal12 steps Emergency SW Installation on a New, Empty Internal CF Card6 steps Emergency SW Installation on a Printer in "Error - System Failure" State4 steps Adjusting Image Quality at the Printer (LUT, Interpolation, Dmax)6 steps Infocounter — Purpose and How to Access It (Report vs. Service Command Session)12 steps

View all DryStar 5300 guides

Source: DD+DIS346.05E — Drystar 5300, Repair and Service: Controls, Connections and Set Up Procedures, Chapter 1 §5.6 "Entering Site Data", Edition 1, Revision 10 (2006-01-26), document p.56 (chapter-relative footer "Chapter 1 / 24"). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.