ProcedureSoftwareInstallation

Post-upgrade — confirm new SW version and re-run film calibration

Once the SW 2.0.0_C1 upgrade has finished, confirm the key-operator menu now reports the new release and re-run film calibration, reading the result against the target Dmax for the densitometer configured on the printer.

Applies to
DryStar 5300 — this section's own document footer labels the printer "(Type 5365)" (no "/100" suffix) — source Chapter 7, §4.1/§4.2, Field Modifications (DD+DIS350.05E), Edition 1, Revision 9 (2006-01-20), document p.471-472. Other atoms in this corpus, sourced from a different document (DD+DIS346.05E), label the same printer "Type 5365/100" — both refer to the DryStar 5300 dry film imager; not reconciled here.
Personnel
Service-level technician or key-operator, comfortable reading the key-operator menu's software-version screen and running/reading a film calibration from the local keypad. Source assigns no formal skill-level label to this section (derived).
Steps
4 steps
Source
DD+DIS350.05E — Drystar 5300, Field Modifications, Chapter 7, §4 "Finalization of the upgrade" — §4.1 "Check of installed Software Release" and §4.2 "Film Calibration" (chapter-footers "Chapter 7/9" and "Chapter 7/10"), Edition 1, Revision 9 (2006-01-20), document p.471-472.

Full step-by-step for Post-upgrade — confirm new SW version and re-run film calibration

All 4 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Software guides

ADVP — DICOM Test Tool6 stepsPrinter Bootup-Message via HyperTerminal12 stepsEmergency SW Installation on a New, Empty Internal CF Card6 stepsEmergency SW Installation on a Printer in "Error - System Failure" State4 stepsEntering Site Data0 stepsAdjusting Image Quality at the Printer (LUT, Interpolation, Dmax)6 steps
View all DryStar 5300 guides

Source: DD+DIS350.05E — Drystar 5300, Field Modifications, Chapter 7, §4 "Finalization of the upgrade" — §4.1 "Check of installed Software Release" and §4.2 "Film Calibration" (chapter-footers "Chapter 7/9" and "Chapter 7/10"), Edition 1, Revision 9 (2006-01-20), document p.471-472.. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.