Post-upgrade — print test images, compare before/after, adjust contrast and sharpness if needed
After the SW 2.0.0_C1 upgrade, print a fresh set of test images, compare them at the light box against the set printed before the upgrade, and — only if contrast or sharpness genuinely need it — fine-tune the look-up table, interpolation, or Dmax at the printer's key-operator Image Quality menu.
Applies to
DryStar 5300 — this section's own document footers use two forms across its three pages: "(Typ 5365)" (p.472 and p.474 footers) and "(Type 5365)" (p.473 footer) — both transcribed here exactly as printed; source Chapter 7, §4.3/§4.4/§4.4.1, Field Modifications (DD+DIS350.05E), Edition 1, Revision 9 (2006-01-20), document p.472-474. Other atoms in this corpus, sourced from a different document (DD+DIS346.05E), label the same printer "Type 5365/100" — all refer to the DryStar 5300 dry film imager; not reconciled here.
Personnel
Service-level technician or key-operator: print and read test films from the browser pages, do a light-box comparison against the pre-upgrade set, and — only if needed — fine-tune look-up table, interpolation, or Dmax at the key-operator Image Quality menu. No disassembly or measurement instrument called for in this section. Source assigns no formal skill-level label (derived).
Steps
9 steps
Source
DD+DIS350.05E — Drystar 5300, Field Modifications, Chapter 7, §4.3 "Print-out of Test Images," §4.4 "Comparison of Images before and after Software Upgrade," and §4.4.1 "Contrast and Sharpness Adjustment" (chapter-footers "Chapter 7/10" through "Chapter 7/12"), Edition 1, Revision 9 (2006-01-20), document p.472-474.
Full step-by-step for Post-upgrade — print test images, compare before/after, adjust contrast and sharpness if needed
All 9 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Source: DD+DIS350.05E — Drystar 5300, Field Modifications, Chapter 7, §4.3 "Print-out of Test Images," §4.4 "Comparison of Images before and after Software Upgrade," and §4.4.1 "Contrast and Sharpness Adjustment" (chapter-footers "Chapter 7/10" through "Chapter 7/12"), Edition 1, Revision 9 (2006-01-20), document p.472-474.. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.