ProcedureSoftwareInstallation

Software Update via a Remote Computer

Load a software patch onto the DryStar 5300 straight from a networked PC's web browser — no CF card and no local keypad — by driving the printer's own Service Engineer Tools web pages end to end, then confirm the upgrade with a SMPTE test image and one test image per modality.

Applies to

DryStar 5300 (Type 5365/100)

Personnel

1 technician · Service-level technician — establishes a web-browser connection to the printer's own web pages, logs in to the Service Engineer Tools / Key-operator Command Session, browses to and uploads a vendor-supplied software-patch ZIP, and follows the on-screen prompts through to completion. No local keypad, disassembly, or bench equipment is needed for the upload itself. Source assigns no formal skill-level label to this section (derived).

Steps

5 steps

Source

DD+DIS346.05E — Drystar 5300 Repair and Service, Machine specific tools, software tools and auxiliary means, Chapter 3.2/39-40, §3.1.2 "Software Update via a remote Computer," Edition 1, Revision 7, 2006-01-26 (Type 5365/100)

Tools & parts

Item	Part number	Qty
Web browser + network connection to the printer	n/a in source	1 (derived — source lists this as a precondition, not a counted line item)
Software-patch ZIP file (e.g. `DS5300_SWR_180C1.zip`)	n/a in source	1 (derived — source gives this only as an example filename, not a counted line item)

Safety

NOTICE

Hazard: Depending on the software patch version, the software upgrade may re-program one of the printer's boards.

Consequence: If that re-programming is interrupted by a power loss, the affected board may become unusable.

Avoidance: Do not reboot the printer before requested by the web pages.

Full step-by-step for Software Update via a Remote Computer

All 5 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.

Open the full procedure

Related Software guides

ADVP — DICOM Test Tool6 steps Printer Bootup-Message via HyperTerminal12 steps Emergency SW Installation on a New, Empty Internal CF Card6 steps Emergency SW Installation on a Printer in "Error - System Failure" State4 steps Entering Site Data0 steps Adjusting Image Quality at the Printer (LUT, Interpolation, Dmax)6 steps

View all DryStar 5300 guides

Source: DD+DIS346.05E — Drystar 5300 Repair and Service, Machine specific tools, software tools and auxiliary means, Chapter 3.2/39-40, §3.1.2 "Software Update via a remote Computer," Edition 1, Revision 7, 2006-01-26 (Type 5365/100). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.