TroubleshootingDiagnosticsTroubleshootingTroubleshooting
Message "Error System Failure"
After power-on, the Drystar 5300's LCD shows **"ERROR System Failure"** and the printer never finishes starting up — this happens because the operating system (and with it, Online Diagnosis) could not boot completely, and the terminal-based checks below isolate whether the internal CF card or its software payload is at fault before you consider swapping hardware.
Applies to
Drystar 5300, Type 5365/100 — source Chapter 3.3, "Message 'Error System Failure'" (this message covers a printer whose operating system / Online Diagnosis fails to complete startup; confirm the LCD wording matches exactly before following this flow, since other bootup failures on this printer are documented separately).
Personnel
1 technician · Service-level technician — requires a terminal connection to the printer and the ability to log in at the OS prompt with username "mega" plus the service password (both stated directly in source); comfort with basic DOS-style commands (cd, dir) is assumed.
Steps
3 steps
Source
DD+DIS346.05E p.167-168
Full step-by-step for Message "Error System Failure"
All 3 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Diagnostics guides
Performing the Acceptance Test3 stepsBlank LCD Display0 stepsBubbles0 stepsContouring Visible; 'Landscaping'0 stepsContrast and/or Sharpness Not Okay0 stepsDensity Reproduction Not Okay0 steps
View all DryStar 5300 guidesSource: DD+DIS346.05E p.167-168. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.