ProcedureDiagnosticsInstallationInstallation
Performing the Acceptance Test
Close out the DryStar 5300 installation by proving, against the acceptance-test regulation that applies at the site, that the printer reproduces the image from the monitor on film — then log the time under installation-report task code APPL.
Applies to
Drystar 5300, Type 5365 — source Chapter 1, "Controls, Connections and Set Up Procedures," Edition 1, Revision 10 (2006-01-26), §8 "Acceptance Test," document p.69-70.
Personnel
Knowledge of the acceptance-test regulation that applies at the installation's country/site (source's own worked example: Germany's DIN6868 Part 56), and the ability to check the printer's console output against that regulation's criteria (Figure 36). No disassembly, calibration, or diagnostic-software step is stated in this section. (derived — source does not assign a formal skill-level label to this section.)
Steps
3 steps
Source
DD+DIS346.05E — Drystar 5300, Controls, Connections and Set Up Procedures, Chapter 1, §8 "Acceptance Test", Edition 1, Revision 10 (2006-01-26), document p.69-70 (chapter-relative footers "Chapter 1/37" and "Chapter 1/38")
Full step-by-step for Performing the Acceptance Test
All 3 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Diagnostics guides
Blank LCD Display0 stepsBubbles0 stepsContouring Visible; 'Landscaping'0 stepsContrast and/or Sharpness Not Okay0 stepsDensity Reproduction Not Okay0 stepsDmax Too High or Too Low0 steps
View all DryStar 5300 guidesSource: DD+DIS346.05E — Drystar 5300, Controls, Connections and Set Up Procedures, Chapter 1, §8 "Acceptance Test", Edition 1, Revision 10 (2006-01-26), document p.69-70 (chapter-relative footers "Chapter 1/37" and "Chapter 1/38"). Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.