TroubleshootingDiagnosticsTroubleshooting
Bubbles
When a printed film shows clusters of small pinholes in the Dmax (black) area — visible only under a magnifying glass, and gone once you lower the Dmax — work through the three-stage film/CDM calibration escalation below before you reach for a different roll of film.
Applies to
DryStar 5300 (Type 5365/100)
Personnel
1 technician · Service-level technician — evaluates the film with a magnifying glass, runs the STI1 test image, and works through the film-calibration / CDM-calibration / film-batch-swap escalation; no disassembly required for this entry itself (derived — source does not assign a formal skill-level label to this section).
Steps
0 steps
Source
DD+DIS346.05E — Drystar 5300 Repair and Service, Troubleshooting, Chapter 3.3 (item 11.4.2), p.30, Edition 1 Rev.7
Full step-by-step for Bubbles
All 0 steps are documented in the FSELIB DryStar 5300 service manual — re-authored, web-first, with the real figures from the source.
Open the full procedureRelated Diagnostics guides
Performing the Acceptance Test3 stepsBlank LCD Display0 stepsContouring Visible; 'Landscaping'0 stepsContrast and/or Sharpness Not Okay0 stepsDensity Reproduction Not Okay0 stepsDmax Too High or Too Low0 steps
View all DryStar 5300 guidesSource: DD+DIS346.05E — Drystar 5300 Repair and Service, Troubleshooting, Chapter 3.3 (item 11.4.2), p.30, Edition 1 Rev.7. Preview re-authored by FSELIB — the full procedure with figures and steps is in the paid service manual.