What is Agfa CT error code HC11219?

Sheet positioning for the MDM calibration scan failed (output jam). It is reported by the MDM (Macrodensitometer) Module on DryStar 5500 and DryStar 5503 CT systems. Severity: Alarm; subsystem: MDM (Macrodensitometer) Module — Sheet Positioning for Calibration Scan.

What should a field engineer do about HC11219?

Clear the output jam and check the sheet transport path around the MDM module for an obstruction or mechanical fault preventing the sheet from being positioned for the calibration scan.. Isolate the MDM (Macrodensitometer) Module — Sheet Positioning for Calibration Scan subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the DryStar 5500 / DryStar 5503.

AlarmMDM (Macrodensitometer) Module — Sheet Positioning for Calibration Scan

HC11219 — Sheet positioning for the MDM calibration scan failed (output jam)

Agfa CT error code, reported by the MDM (Macrodensitometer) Module.

What HC11219 means

On DryStar 5500 and DryStar 5503 CT systems, status code HC11219 indicates: Sheet positioning for the MDM calibration scan failed (output jam). The code originates in the MDM (Macrodensitometer) Module — Sheet Positioning for Calibration Scan section of the MDM (Macrodensitometer) Module. Severity level alarm (Alarm).

Reported action: Clear the output jam and check the sheet transport path around the MDM module for an obstruction or mechanical fault preventing the sheet from being positioned for the calibration scan..

Raised on the DryStar 5500/5503 when the printer fails to position a sheet for the MDM calibration scan. The printer shows "Remove output jam". Filed with the other MDM/densitometer fault codes (HC10200, HC10819-HC10820, HC10904-HC10905, HC10920, HC11005, HC11110-HC11115, HC11124, HC11218-HC11222).

Full troubleshooting for HC11219

The complete diagnosis, cause tree, and step-by-step remedy for the MDM (Macrodensitometer) Module — Sheet Positioning for Calibration Scan subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related MDM (Macrodensitometer) Module — Sheet Positioning for Calibration Scan codes

HC10053Themis board CPU too hot HC10100MEC PCB test failed HC10814Drum passed sensor S24 not connected or malfunctioning HC10815Drum entry sensor S23 not connected or malfunctioning HC11000Firewire cable between Crius and Themis boards not connected or faulty HC1100124V actuator power not available on the MEC board HC1100324V / 12V / 5V voltages not OK on the MEC board HC11006Connector P21 not detected on the MEC board

Discuss HC11219 with other field engineers in the FSELIB forum

Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.