AlarmMDM (Macrodensitometer) Module — Initialization / Calibration

HC11124 — MDM module initialization or calibration failed

Agfa CT error code, reported by the MDM (Macrodensitometer) Module.

What HC11124 means

On DryStar 5500 and DryStar 5503 CT systems, status code HC11124 indicates: MDM module initialization or calibration failed. The code originates in the MDM (Macrodensitometer) Module — Initialization / Calibration section of the MDM (Macrodensitometer) Module. Severity level alarm (Alarm).

Reported action: Check the MDM module — the initialization failure is caused either by a homing failure or by a bulb-check failure (light intensity too low, or too much stray light detected)..

Raised on the DryStar 5500/5503 when initialization or calibration of the MDM (macrodensitometer) module fails. Filed with the other MDM/densitometer fault codes (HC10200, HC10819-HC10820, HC10904-HC10905, HC10920, HC11005, HC11110-HC11115, HC11124, HC11218-HC11222).

Full troubleshooting for HC11124

The complete diagnosis, cause tree, and step-by-step remedy for the MDM (Macrodensitometer) Module — Initialization / Calibration subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related MDM (Macrodensitometer) Module — Initialization / Calibration codes

HC10053Themis board CPU too hotHC10100MEC PCB test failedHC10814Drum passed sensor S24 not connected or malfunctioningHC10815Drum entry sensor S23 not connected or malfunctioningHC11000Firewire cable between Crius and Themis boards not connected or faultyHC1100124V actuator power not available on the MEC boardHC1100324V / 12V / 5V voltages not OK on the MEC boardHC11006Connector P21 not detected on the MEC board
Discuss HC11124 with other field engineers in the FSELIB forum

Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.