What is Agfa CT error code HC11115?

MDM measurement failed due to corrupt or unsuitable input data. It is reported by the MDM (Macrodensitometer) Module on DryStar 5500 and DryStar 5503 CT systems. Severity: Alarm; subsystem: MDM (Macrodensitometer) Module — Measurement / Calibration Scan.

What should a field engineer do about HC11115?

Re-run the MDM calibration scan. If it keeps failing, check the MDM module itself (light source, sensor, transport) for the underlying cause of the bad measurement data before continuing.. Isolate the MDM (Macrodensitometer) Module — Measurement / Calibration Scan subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the DryStar 5500 / DryStar 5503.

AlarmMDM (Macrodensitometer) Module — Measurement / Calibration Scan

HC11115 — MDM measurement failed due to corrupt or unsuitable input data

Agfa CT error code, reported by the MDM (Macrodensitometer) Module.

What HC11115 means

On DryStar 5500 and DryStar 5503 CT systems, status code HC11115 indicates: MDM measurement failed due to corrupt or unsuitable input data. The code originates in the MDM (Macrodensitometer) Module — Measurement / Calibration Scan section of the MDM (Macrodensitometer) Module. Severity level alarm (Alarm).

Reported action: Re-run the MDM calibration scan. If it keeps failing, check the MDM module itself (light source, sensor, transport) for the underlying cause of the bad measurement data before continuing..

Raised on the DryStar 5500/5503 when an MDM (macrodensitometer) measurement fails because the measurement input data is corrupt or unsuitable. The printer shows "Calibration module not working". Filed with the other MDM/densitometer fault codes (HC10200, HC10819-HC10820, HC10904-HC10905, HC10920, HC11005, HC11110-HC11115, HC11124, HC11218-HC11222).

Full troubleshooting for HC11115

The complete diagnosis, cause tree, and step-by-step remedy for the MDM (Macrodensitometer) Module — Measurement / Calibration Scan subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related MDM (Macrodensitometer) Module — Measurement / Calibration Scan codes

HC10053Themis board CPU too hot HC10100MEC PCB test failed HC10814Drum passed sensor S24 not connected or malfunctioning HC10815Drum entry sensor S23 not connected or malfunctioning HC11000Firewire cable between Crius and Themis boards not connected or faulty HC1100124V actuator power not available on the MEC board HC1100324V / 12V / 5V voltages not OK on the MEC board HC11006Connector P21 not detected on the MEC board

Discuss HC11115 with other field engineers in the FSELIB forum

Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.