HC11108 — Thermal head heating temperature out of range
Agfa CT error code, reported by the Thermal Print Head (TH) Module.
What HC11108 means
On DryStar 5500 (Type 5364/100) and DryStar 5503 (Type 5364/300) CT systems, status code HC11108 indicates: Thermal head heating temperature out of range. The code originates in the TH Module — Warning Message (Undocumented Cause) section of the Thermal Print Head (TH) Module. Severity level warning (Warning).
Reported action: This is a stub warning code — the appendix gives no documented Reason, Cure or Part for it. Read the code under Service menu > Show error > Last error code, then run the printer's Test & Diagnose functions covering the thermal head and its interface board (THIB). Like the module's other Warning-type codes, the engine keeps printing while this message is shown, though image quality may suffer until the underlying cause is found..
Raised on the Drystar 5500/5503 thermal print head (TH) module as a Warning Message-only code — the source documents no Reason, Cure or replacement part for it, only the local display text. Catalogued in the appendix's TH-module fault-code table alongside the head's voltage, heater, fan, connectivity and thermistor codes (HC10305-HC11120).
Full troubleshooting for HC11108
The complete diagnosis, cause tree, and step-by-step remedy for the TH Module — Warning Message (Undocumented Cause) subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.
Open the Activion16 service manualRelated TH Module — Warning Message (Undocumented Cause) codes
Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.