What should a field engineer do about HC10819?

The source gives no specific repair steps for this code. Check the MDM module's light sensor and its connections/wiring to the MEC board before replacing the sensor or the DSH board.. Isolate the MDM Module — Light Sensor subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the DryStar 5500 (Type 5364/100) / DryStar 5503 (Type 5364/300).

AlarmMDM Module — Light Sensor

HC10819 — MDM light sensor failure

Q: What is Agfa CT error code HC10819?

MDM light sensor failure. It is reported by the MDM / Densitometer Module on DryStar 5500 (Type 5364/100) and DryStar 5503 (Type 5364/300) CT systems. Severity: Alarm; subsystem: MDM Module — Light Sensor.

Agfa CT error code, reported by the MDM / Densitometer Module.

What HC10819 means

On DryStar 5500 (Type 5364/100) and DryStar 5503 (Type 5364/300) CT systems, status code HC10819 indicates: MDM light sensor failure. The code originates in the MDM Module — Light Sensor section of the MDM / Densitometer Module. Severity level alarm (Alarm).

Reported action: The source gives no specific repair steps for this code. Check the MDM module's light sensor and its connections/wiring to the MEC board before replacing the sensor or the DSH board..

Raised on the Drystar 5500/5503 MDM (macrodensitometer) module as a light sensor failure. The keypad shows "MDM lightsensor fails". The source does not give a Reason or Cure for this specific code.

Full troubleshooting for HC10819

The complete diagnosis, cause tree, and step-by-step remedy for the MDM Module — Light Sensor subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related MDM Module — Light Sensor codes

HC10053Themis board CPU too hot HC10100MEC PCB test failed HC10814Drum passed sensor S24 not connected or malfunctioning HC10815Drum entry sensor S23 not connected or malfunctioning HC11000Firewire cable between Crius and Themis boards not connected or faulty HC1100124V actuator power not available on the MEC board HC1100324V / 12V / 5V voltages not OK on the MEC board HC11006Connector P21 not detected on the MEC board

Discuss HC10819 with other field engineers in the FSELIB forum

Source: AGFA DryStar service manual — HC error catalogue (FSELIB authored corpus). Reference information re-authored by FSELIB — not a copy of the OEM manual.