Cannot Scan With Coil Plugged into LPCA Upper Port.

Cannot Scan With Coil Plugged into LPCA Upper Port. Coil ID Does Not See Any Coil in LPCA Upper Port See Long Description This is a research site that builds and uses their own coils. This coil ID failure began right after the customer had plugged in one of their research coils that they had built. The Coil ID LED stays dark and does not recognize any coil plugged into the LPCA's upper port. However they can continue to scan with any multicoil plugged into the LPCA's lower port. The error message shown below is logged on system reboot: Fri Feb 15 09:30:40 2008 2224862 2 CB-3TMR NSP SCP:SRI 575 Coil ID Warning. Information returned from the coil indicates the coil does not contain a valid ID. An older coil that has not been upgraded with coil ID would fail in this way. If this is instead a newer coil, the coil may be programmed incorrectly. The error message shown below is logged when trying to scan with a coil plugged into the LPCA's upper port: Fri Feb 15 09:40:16 2008 2220008 5 CB-3TMR scn RxMgrDownload.m 2148 RF coil connection failure detected, reconnect coil and if problem persists contact GE Service. Upper coil connect status:0, Upper coil code:Null, Lower coil connect status:1, Lower coil code:Null