Innova, Unable to complete or failing detector bad pixel gain calibration TSG.
Innova, Unable to complete or failing the detector bad pixel gain calibration
Symptom
Innova, Unable to complete or failing detector bad pixel gain calibration TSG. . See LD for details on different scenarii that can occur. Innova, Unable to complete or failing detector bad pixel gain calibration Abort of BP calibration before starting computation X-ray abort is displayed 14% into the fifth exposure. Bad pixel calibration fails at 10% after the first exposure. the first step (offset) passes. the second step aborts after the first exposure. Acquisition does not start and is aborted after a time out of 4000 msecs. Cal fails Failed Results of BP calculation 1/ Segment density out of spec 2/ Bad pixel density out of spec
Error message
Error 4202001 Software recoverable Problem. Bad system inputs, impossible to configure opmodes
Applies to
- Models
- Innova, Advantx
- Product
- Innova X100 Monoplane Innova X100 Monoplane from product name Innova 2100, 3100 and 4100 Innova X100 Monoplane Innova 2100, 3100 and 4100 Innova 2000 Innova 2000 systems Innova 2000 systems Innova X1 X1 Biplane Innova X1 X1 Bi-plane Innova 2121 or 3131 Bi-plane System Innova X1 X1 Bi-plane Innova 2121 or 3131 Bi-plane System
- Area
- X-ray Vascular
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray Vascular issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray Vascular issues
- The Worklist does not refresh on the system when performing a query.
- Innova System boot failure
- INX1X; Message Limit switch engaged; LP4 Lateral Detector lift will not move after going to max SID using the Emergency Backout button on the lift cover because the lift hit maximum (Max) SID limit sw…
- Firewall is broadcasting DHCP addresses
- Cooling Failure; Shut System down and call Service is displayed on the Innova Image monitor
- No gantry motion is reported by the customer.