GE Healthcare · X-ray VascularAdvantxInnova
LCA, LCV positioner F9 on AC/DC power supply opens when II enable pressed on the Smart Box
Symptom
LCA, LCV positioner F9 on AC/DC power supply opens when II enable pressed on the Smart Handle LCA, LCV positioner, F9 on AC/DC power supply opens when II enable pressed on the Smart Handle. Motion is therefore not possible using the Smart Handle. However, II motion is possible: either from up/down Switch ring buttons or using gantry enable instead of II enable.
Applies to
- Models
- Advantx, Innova
- Product
- Advantx E Monoplane Advantx E Systems advantx e, vamp Advantx E generator Systems Advantx, LFX Advantx product line LFX Advantx product line Advantx E Biplane Advantx E biplane systems: LCLP+ (22 cm II), LCN+ (32 cm II), LCALP+ (40 cm frontal plane, 32 cm lateral plane) Advantx E biplane systems: LCLP+ (22 cm II), LCN+ (32 cm II), LCALP+ (40 cm frontal plane, 32 cm lateral plane)
- Area
- X-ray Vascular
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray Vascular issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray Vascular issues
- The Worklist does not refresh on the system when performing a query.
- Innova System boot failure
- INX1X; Message Limit switch engaged; LP4 Lateral Detector lift will not move after going to max SID using the Emergency Backout button on the lift cover because the lift hit maximum (Max) SID limit sw…
- Firewall is broadcasting DHCP addresses
- Cooling Failure; Shut System down and call Service is displayed on the Innova Image monitor
- No gantry motion is reported by the customer.